Replacement filters are available for a broad range of climate control enclosure applications.
Filter Mats for Tangential Fans
This chopped-fiber mat provides reliable filtering of virtually all types of dust with particle sized 10 µm and larger with an open structure on its dust-laden air side and a closed structure on the clean-air side. It is temperature-resistant to 100°C and compliant with self-extinguishing category F1 to DIN 53 438.
Rittal electronic cooling units and air/air heat exchangers are low maintenance and are supplied without filter mats. However, filter mats may be added for use in extreme conditions.
Our washable metal filters are ideal for a wide range of enclosure types when cooling units are located in dusty and oily environments. When air or steam condenses on the surface of the metal, particles adhere to it, and then can be washed out easily with water or solvents.
Spare Filter Mats
Always keep a supply of replacement filters on hand to ensure a continuous supply of clean filtered air for your electronics enclosures. The chopped fiber mats are sized for use in fan-and-filter units, filter holders, Thermoelectric Coolers, and EMC fan-and-filter units.
Fine Filter Mats for Fan-and-Filter Units
These fine filter mats are sold in packs of 5 so you won’t run out when it’s time to maintain your fan-and-filter units. They provide reliable filtering of virtually all types of dust with particle sized 10 µm and larger with an open structure on its dust-laden air side and a closed structure on the clean-air side. It is temperature-resistant to 100°C and compliant with self-extinguishing category F1 to DIN 53 438.
Outlet Filter: Standard
These ABS outlet filters are designed for installation in the upper and lower sections of an electronics enclosure to allow for ventilation by convection.
Outlet Filter: EMC
EMC fan-and-filter units demand the use of special filter mats. EMC protection can only be guaranteed when you use original Rittal EMC filter media.
These hoods are designed to provide a higher category of protection when fitted over a fan-and-filter unit/outlet filter with filter mat. Its exterior silicone coating, approved for use with foodstuffs, allows for easy cleaning.
If you need to close existing mounting cutouts for fan-and-filter units/outlet filters in order to achieve a higher protection category, simply replace the filter mat of the fan-and-filter unit/outlet filter with this blanking cover. There’s no need for welding or other mechanical modification of the enclosure.
Front Outlet Grille for Tangential Fans
Use this 2 U front outlet grille if a 19″ cross-flow blower is installed in the lower section of the electronic enclosure and the hot air is to be expelled to the outside from the enclosure’s upper section. The grille’s design matches the intake grille in the cross-flow blower. These grilles can also be used as simple inflow and outflow grilles with natural convection.
Filter Holder for Roof Ventilation
A filter mat and this filter holder are required to increase the protection category of the SK 3148.007 roof vent.
Enclosure Internal Fans
Three different models of adjustable fans can be positioned to prevent hot spots inside a TS 8 electronics enclosure and to support other climate control components. A quick-release clamping strip allows cascading multiple fans.
This compact DC fan is designed for enclosure cooling and component cooling within enclosures.
These easy to install louvers support ventilation by convection; they can be easily retrofitted to an enclosure using just 4 screws.